E6000 Plus

Follow these step-by-step instructions when using the E6000 PLUS:

Read instructions and test a small area for adhesion before use. Surface must be clean, dry and free of dirt. For best adhesion on smooth, non-porous materials, lightly roughen the surface before use. Ideal application temperature range is 50 to 90 ºF (10 to 32 ºC). Once fully cured, the adhesive can withstand temperatures from -40 to 93 ºC (-40 to 200 ºF) intermittently.

1. Puncture the seal in the neck of the tube using the pointing cap.
2. Apply directly to surfaces to be bonded or repaired. NOTE: For non-porous surfaces, apply adhesive, bring surfaces together, pull apart for 5 minutes, then permanently bond surfaces together.
3. To close the tube properly, remove the air in the tube by squeezing the product slightly past the end of the opening, then replace the cap. Dried product can be easily removed.
4. Allow 24 hours for full cure. Depending on substrate and temperature, maximum bond strength may not be reached for up to 72 hours.
5. Clean uncured adhesive with alcohol, mineral spirits, acetone or a dry cloth. Cured material can be removed with mineral spirits or by cutting or scraping.
6. Not recommended for use on acrylic, vinyl, foam, polyethylene and polypropylene. Store in a cool, dry place.

Tip: For quick emergency repairs, lightly mist the substrate with moisture before applying adhesive.

How long does it take for the E6000 PLUS to dry?

Allow 24 hours for full cure. Depending on substrate and temperature, maximum bond strength may not be reached for up to 72 hours.

Can the courtship period be accelerated?

Yes, for quick emergency repairs, lightly mist the substrate with moisture before applying adhesive. Application to damp and wet surfaces may slightly affect adhesion.

How can the E6000 PLUS be cleaned up?

Clean uncured adhesive with alcohol, mineral spirits, acetone or a dry cloth. Cured material can be removed with mineral spirits or by cutting or scraping.

What temperature is best to use the E6000 PLUS?

Ideal application temperature range is 50 to 90ºF (10 to 32ºC). Once fully cured, the adhesive can withstand temperatures from -40 to 93ºC (-40 to 200ºF) intermittently.

Is the E6000 PLUS waterproof, UV resistant and washer/dryer safe?

Yes.

Can E6000 PLUS be overpainted once it has cured?

Yes. Can be painted over most brands/types of water-based paint. Test a small area before use.

What is the best way to extend the life of unused product in the tube?

After use, remove the air in the tube by squeezing the product slightly past the end of the opening and then close the cap tightly. Dried product can be easily removed.

What materials can the E6000 PLUS be used on?

Use on all your INDOOR/OUTDOOR DIY or craft projects that require a permanent bond. EXCELLENT ADHESION TO: Wood, glass, fabric, ceramics, gemstones, metals, marble, fiberglass, concrete, most plastics, Lexan, plexiglass, much more!

What is the best way to clean the E6000 PLUS?

Clean uncured adhesive with alcohol, mineral spirits, acetone or a dry cloth. Cured material can be removed with mineral spirits or by cutting or scraping.

Can E6000 PLUS be sanded?

Yes, E6000 PLUS sands easily. The cured adhesive will be sanded off at different speeds depending on the grit of the sandpaper. Carefully cut away as much cured excess as possible. Use the coarsest sandpaper (e.g. 60 or 80) to eliminate the excess. Then a finer sandpaper (e.g. above 200) for finishing.

E6000 Plus SDS (UK)

E6000 Plus SDS (ENG)